Marshall JCM2000 repair
I get quite a lot of the JCM2000 series in for repair – both DSL and TSL. I think it’s because they were so popular, rather than any endemic issues. This particular JCM2000 is a TSL100, the triple super lead model.
I’m writing the blog post quite a while after the repair now, so I’m looking at my notes to remember the issue. IIRC, the amp needed new valves and the owner mistakenly paired valves 1+2, 3+4, instead of the correct 1+4, 2+3. He knew how to bias his own amp and knew about pairing valves, but had always replaced for a matched quad in the past. When he paired the valves wrongly things had become hot and smokey – the valves red-plated For more information on valve amp bias, check my bias FAQ.
The amp had become so hot that a screen grid resistor (R78) – mounted upside down in the amp – had melted its solder connection and fallen out of the amp, melting some cabling where it landed. I replaced this resistor (with a lighter weight, but equally rated component). I also replaced the burned out suppression capacitor that can be seen in the picture.
The lesson to be learned: read my bias FAQ before replacing power valves yourself. If in doubt, ask!
If you have a JCM2000 repair, do get in touch.